WYBOT S2 High-end Cordless Robotic Pool Cleaner

The WYBOT S2 is WYBOT’s high-end cordless cleaner, built for large pools. It cleans floors, walls including tile, steps, and waterlines, driven by three powerful brushless motors that deliver 3,592 GPH of suction. It is rated for pools up to 3,230 square feet and runs up to 210 minutes on a single charge, with a quick three-hour recharge.

A dual-layer filter pairs a 180 micron filter with an ultra-fine cotton foam layer to capture both large debris and fine particles. Through the WYBOT app you can choose from seven cleaning modes and six paths, and you can also select from three modes directly on the unit without a phone. A cycle timer schedules up to four cleanings a week.

When the cycle ends or the battery runs low, the S2 parks itself at the pool edge for easy retrieval. For hands-free, self-charging operation, the S2 Solar adds an underwater solar charging dock, and the S2 Solar Vision adds an AI camera.

• Triple-Motor Brushless Suction: Three brushless motors deliver 3,592 GPH of suction to lift dirt, leaves, and debris from large pools.
• Comprehensive Cleaning: Cleans floors, walls including tile, steps, and waterlines for complete coverage.
• Long Runtime for Large Pools: Runs up to 210 minutes per charge, covering pools up to 3,230 square feet, and recharges in about three hours.
• Dual-Layer Filtration: A 180 micron filter captures larger debris, and an ultra-fine cotton foam layer traps fine particles for clearer water.
• App and On-Unit Control: Choose seven modes and six paths in the WYBOT app, or pick from three modes on the unit without a phone. A cycle timer schedules up to four cleanings a week.
• Smart Self-Parking: Returns to the pool edge when finished or low on battery for easy retrieval.

The S2 suits owners of large in-ground pools up to 3,230 square feet who want full cleaning of floors, walls, steps, and waterlines with long runtime. It works on all common pool surfaces, including tile, and handles above-ground and in-ground pools.

The S2 uses a standard charger; you remove it to charge between cycles. If you would rather the cleaner recharge itself and run on a schedule without handling, the S2 Solar adds an underwater solar charging dock, and the S2 Solar Vision adds AI camera debris detection on top of that.

1. Charge the unit: Charge the S2 fully before first use. A full charge takes about three hours. Twist the charging port cover tightly before placing the unit back in the water.
2. Install the app: Download the WYBOT app, create or sign in to an account, and connect over Wi-Fi. You can also operate the unit using its on-board modes without the app.
3. Choose a mode: Select a cleaning mode and path in the app, or pick one of the three on-unit modes. Set the cycle timer for recurring cleanings if desired.
4. Place and run: Lower the S2 into the pool and start the cycle.
5. Retrieve and clean: When it parks at the edge, lift it out, then rinse the filter and foam under a hose. Replace the foam with the cut side oriented correctly so the lid closes.