(2026 Upgrade) WYBOT C2 Cordless Robotic Pool Cleaner

The WYBOT C2 is a cordless robotic pool cleaner for mid-sized pools that builds on the C1 with a brushless motor, higher suction, and dual-layer filtration. It cleans the floor, walls, and waterline, along with steps and slopes, and parks itself at the pool edge when it finishes.

A brushless triple-motor system delivers 3,592 GPH of water flow, and a dual-layer filter pairs a 180 micron box with a 10 micron ultra-fine filter to capture everything from leaves to fine dust, with a 3 liter capacity. The unit is rated for pools up to 2,152 square feet and runs up to 180 minutes per charge in Eco mode, recharging in about three hours.

Through the WYBOT app you can choose from seven cleaning modes and six paths, schedule up to four cleanings a week, and receive over-the-air updates. For added AI debris detection, the C2 Vision builds on this platform with an onboard camera.

• Brushless Motor and Cordless Design: A brushless triple-motor system delivers strong, efficient 3,592 GPH performance with no cord or hose to tangle.
• Dual-Layer Filtration: A 180 micron filter box captures leaves and sand, and a 10 micron ultra-fine filter traps fine dirt and algae, with a spacious 3 liter capacity. Use the fine filter in Turbo mode for the deepest clean.
• Full Coverage Cleaning: Cleans the floor, walls, and waterline plus steps and slopes for complete pool maintenance.
• 7 Modes and 6 Paths: Choose Full, Floor, Wall, Waterline only, Wall then Floor, Turbo, or Eco, and customize routes in the WYBOT app.
• Scheduling and Updates: Schedule up to four cleanings per week and receive over-the-air software updates.
• Smart Self-Parking: Returns to the pool edge when the cycle ends or the battery runs low for easy retrieval.

The C2 suits owners of mid-sized above-ground and in-ground pools up to 2,152 square feet who want cordless cleaning with stronger suction and finer filtration than the entry C1. It handles all common pool shapes and surfaces, including tile, concrete, vinyl, and fiberglass.

The dual-layer filter, down to 10 micron, makes it a good fit for pools that collect fine debris such as sand, pollen, or dead algae. Note that the fine filter clogs faster in heavily soiled water and may need rinsing partway through a cycle. For pools that need targeted AI debris detection, step up to the C2 Vision.

1. Charge the unit: Charge the C2 fully before first use. A full charge takes about three hours. Make sure the unit is off and the charging port is dry before connecting.
2. Install the app: Download the WYBOT app, create or sign in to an account, and connect over Wi-Fi.
3. Pick a mode on land: Select a cleaning mode and path in the app while the unit is out of the water. For fine debris, install the 10 micron filter and use Turbo mode.
4. Place and run: Lower the C2 into the pool and start the cycle.
5. Retrieve and clean: When it parks at the edge, lift it out, remove and rinse both filters, and store the unit out of direct sunlight.